Technical News
Find what you need fast and easily
September 2022
9/26/2022
- Dimension of Frame adjuster installation has been corrected.
- Dimension perforation of Milling for Middle Handle 380-85-012-XX.
- Dimension perforation of Milling for cylinder 35-10-35 (40/40) EX-460-34-040-00 has been corrected
9/26/2022
- New typology No7 One sash window with fixed panel - outwards opening has been added
9/26/2022
- The sash polyamide has been corrected in profile S85056, for easier installation of the reinforcing plate, while placing the striker.
9/13/2022
- Cutting of Interlock PVC code 6604405000 has been corrected in typology PS7 in H-50.8
9/13/2022
- Sash M65146 added on the chapter of profiles, typologies sections and on the chapter of milling-tooling operation regarding the corner cleats of the sash and its installation.
- The chapter of accessories has been updated
August 2022
8/29/2022
- Draining machinings have been corrected on the tracks from 11,4mm to 12mm
8/2/2022
- Add-on profile S67905 added on the chapter of profiles
8/2/2022
- Add-on profile S67905 added on the chapter of profiles
8/2/2022
- Cutting for adjoining sash profile S85030 for 2-ply typologies has been corrected.
- Installation of 310-85-45-000 (set of flanges for even number typologies) added on the chapter of Assembly for accessories page 284.
- Installation of Add on Profiles 2+2 from the side of rolller hinge added on the chapter of Assembly for accessories page 285
8/2/2022
- Secondary sash width for locking rod 440-08-670-00 added on page 13.
- In Aller Retour Second Sash Mechanism the following accessories have been added: 474-37-330-00 Upper latch keeper for doors and 474-03-738-00 Lower latch deep keeper for doors page 14
8/2/2022
- Brush pile seal 620-11-500-00 has been replaced by 620-69-114-03 for optimal operation in typologies 48&49 (aller retour doors)
8/2/2022
- Intermediate Lock Installation has been added on the chapter of general milling-tooling operation
8/2/2022
- 4 new European Groove AK8 Hardware typologies (40-43) for concealed sash added on the technical catalogue
July 2022
7/18/2022
- Insulating glazing gasket 200-06-860-01 replaced by 200-06-861-01 in the chapter of accessories for optimal operation
7/18/2022
- 6604542102 Pvc cuttings have been corrected for the typologies Pls 1, Pls 3, Pls 5, Pls 6 (45 degrees cut) page 32
- M4542 lift & slide sash and 6604542102 Pvc cuttings have been corrected for the typologies Pls2 and Pls4 (90 degrees cut) page 33
7/18/2022
- Sash gasket 2400045420, which is installed by sliding through, that is compatible only with mechanical corners replaced by 2400045601, which is installed by pressing into the groove and is compatible both with crimp and mechanicals corners
7/18/2022
- Cuttings of waterproofing profile S61317 have been corrected.
- Cuttings of Adjoining profile S67658 have been corrected.
- No head metric screw 798-83-305-06 added for the connection of the profile S67005 with the frame of the system.
7/18/2022
- New typology has been added: Outward opening, 3 panels on one side folding door with secondary door