Technical News
Find what you need fast and easily
October 2023
10/3/2023
- Accessories 6603160913 και 6603065213 (inner support plates) have been added.
- Note has been added that in the case of S650 with subsill the upper central seal must be removed before installing the interlock caps 311316043 and 3113160953
10/3/2023
- The solution of top hung flyscreen has been removed (All profiles and accessories related to it have been removed)
10/3/2023
- The solution of top hung flyscreen has been removed
September 2023
9/15/2023
- Roller extension machining has been added
9/15/2023
- Cuttings of low threshold S67684 have been corrected on Single leaf door outward opening typology
9/15/2023
- Cuttings have been changed for sash S35011 in PS5 typology Two Sash Parallel Sliding Window 45 Degrees Cut with Narrow Interlock and Flyscreen
9/15/2023
- Tooling for frame corners 800-20-031-00 has been replaced by 800-20-071-00. Machining drawings have been added.
9/15/2023
- Cuttings of Interlock PVC code 6604548003 have been changed (H-216) in PLS2 and PLS4 typologies due to a change of the end caps
9/15/2023
- Cuttings have been corrected in single sash entrance door opening inward with glass panel typology (No2)
9/15/2023
- Transom M70083, New Shoe bracket AL70002 and its installation have been added
August 2023
8/25/2023
- Footnote for low threshold typologies: Not suggested for exposed openings.
- Footnote for low threshold cap: Keep it only for low threshold
8/25/2023
- T-profiles for glass door sashes S67582, S67882, S67584 have been added on the chapter of profiles index and profiles 1:1
8/25/2023
- Summary of central gaskets & vulcanized corners per version has been added
8/25/2023
- Brush replacement machining for the S50079 profile for the Intergrated Flyscreens IFS has been added
8/25/2023
- Roller 660-28-650-00 has been replaced by 660-29-650-00 and inox rail 660-00-650-00 by 660-01-650-00 for optimal operation. Attention: New roller works only with the new inox rail.
8/25/2023
- Brush replacement machining for the S50079 profile for the Intergrated Flyscreen IFS has been added
8/25/2023
- Brush replacement machining for the S50079 profile for the Intergrated Flyscreen IFS has been added
July 2023
7/27/2023
- Machinings and assembly of the kickplate have been added on the chapter of general milling-tooling operations.
7/27/2023
- Roller Hinge Placement has been added.
- We also add the detail "Always secure all hinges after door installation with the middle screw before glazing"