Technical News
Find what you need fast and easily
March 2022
3/4/2022
- Cutting for Hidden shoot bolt in M8354 has been added on the catalogue
- Basic typologies have been added
3/4/2022
- New in floor base profile M8229 added on the catalogue
3/4/2022
- Locking intermediate mechanism detail added on page 230 of the catalogue
3/4/2022
- Profile cutting lists have been corrected on the typologies 23 & 31
3/4/2022
- Mullion Water Evacuation Machinings have been added on the chapter of Millings page 10
3/4/2022
- Typology icon of the typology No19 was corrected (Single side-hung casement, tilt and turn with fixed and asymmetric T-Profile)
- Profile S77042 was added on profiles of machining tool 852-77-916-00 for the "T" profile of hidden sash page 264
3/4/2022
- Dimensional Limitations chapter has been updated. The diagrams are calculated in compliance with EN 14024.
February 2022
2/22/2022
- Locking solutions for sliding systems catalogue updated with the addition of the M450 system
2/22/2022
- Typology PLS12 Corner assembly with four sash parallel slide (EXTERIOR CORNER) added on the tech catalogue
- Typology PLS13 Corner assembly with four sash parallel slide (INTERIOR CORNER) added on the tech catalogue
- Typologies sections 86 & 87 that refer to the corner typologies added on the specific chapter
- Cuttings of S579 have been corrected in typology FLS1 Fixed - Lift & Slide Window with the Fixed on the Inside and FLS2 Fixed - Lift & Slide Window with Fixed Outside
2/22/2022
- Drainage adaptor code 311-63-163-03 replaced by 311-63-163-04 in all catalogue
- Accessories chapter was updated
2/22/2022
- Flyscreen frame track Μ63145 machining detail added on page 21
- Flyscreen Handle 610-00-701-XX milling added on page 24
2/22/2022
- New typology OUTWARD OPENING, 2+2, 4-PANELS FOLDING DOOR was added on the chapter of sections No 22
- Now, even typologies are activated. All available typologies were updated. 250-85-110-02 Single top gasket and 310-85-450-00 Set of flanges for even typologies were added on the accessories chapter
2/22/2022
- S67032, S67034 & S67036 profiles added on the milling tooling operations of locking (pages 98 & 99)
2/4/2022
- T-cleat inside code 160-11-211-91 has been replaced by 160-11-211-00 in the entire technical catalogue
2/4/2022
- Top central seal 2400450200 replaced by 2400450000 in typology PLS5 (Three Sash Parallel Lift and Slide 45 Degrees Cut Right Opening Window), for optimal operation and long lasting sealing
2/4/2022
- Quantities for the Brush weatherstripping pile trifin code 620-69-306-03 6mm and for the Brush weatherstripping pile code 620-69-106-03 6mm were corrected on all technical catalogue