Technical News
Find what you need fast and easily
June 2023
6/7/2023
- The measurement of the slat 303033, its capacity (Hmax) and all the necessary information for it have been added on the chapter of Extruded Slats
6/7/2023
- Μ63163 gutter machinings for D25 drainage adaptor have been added on page 35
6/7/2023
- New minimal horizontal flyscreen system (IFS typologies) has been added
6/7/2023
- New minimal horizontal flyscreen system (IFS typology) has been added
- Profile Index chapter has been added
6/7/2023
- Fabrication manual has been updated
May 2023
5/26/2023
- Cuttings of Interlock PVC code 6604548003 have been correcting (H-195) in PS7 and PS8 typologies
5/26/2023
- Standard glazing beads have been added on glazing
5/26/2023
- On pages 305 & 306 of the catalogue we demonstrate for all "Τ" profiles which drilling code we use
5/26/2023
- Threshold connection cap 310-11-527-00 for the thresholds S11563, S11527 has been added.
- Threshold connection corner 120-50-300-00 is no longer used.
- Cuttings for the threshold width S11527 and the machinigs of S11563, S11527 have been changed
5/17/2023
- Screw 798-21-242-19 (inox) has been changed into 798-41-242-19 (galvanise).
- Glazing setting blocks position has been added
5/17/2023
- 290-31-702-23 Setting block for 36mm glazing upper side has been added on the table of accessories for double glazing
5/17/2023
- 290-31-702-23 Setting block for 36mm glazing upper side has been added on the table of accessories for double glazing
5/17/2023
- Alignment corner 1807715500 (stainless steel) has been replaced by 1807715501 (aluminium)
- The same for alignment corner 1807701100 (stainless steel) that has been replaced by 1807701101 (aluminium).
- The design of the Profile S77953 has been changed for easier installation
5/17/2023
- Alignment corner 1807715500 (stainless steel) has been replaced by 1807715501 (aluminium)
- The same for alignment corner 1807701100 (stainless steQDel) that has been replaced by 1807701101 (aluminium)
April 2023
4/19/2023
- The chapters of profiles and accessories have been updated
4/19/2023
- In typology 3c Single sash INNER lift & slide with fixed panes we use flush handle 380004223ΧΧ. The flush handle has been added on the chapter of accessories
4/19/2023
- Dimensional limitation for sash S35013-adjoining profile S360-reinforcement M4579-sash S35013
4/19/2023
- Alignment corner 180-77-011-01 corrected into 180-77-155-01 for the hidden sashes Μ19755 and Μ19752 in European Groove Hardware Typologies