Technical News
- Seal gasket 220-11-002-01 replaced with: 220-00-930-03, on typologies: No 1-6
- New typology sash inside of sash added on catalog
- 220-11-449-12 gasket for glazing bead replaced with 220-31-230-03
- Three pages added for lock installation and milling for typologies 2-0, 4-0. You 'll find this information at pages 237-239
- Four new accessories added on page 248
M9660 integrated window into door sash
We have created a new typology in M9660 system, where a window can now be integrated into a door sash. These kind of typologies are used in cases where, the door needs to be closed (or locked) but at the same time, one can open a small window from the inside. Drugstores is a very usual application of this typology.
The typology is available only for euro groove mechanism
M9660 use of same gasket for frame-sash
We have made a small change in the M9660 catalogue concerning euro groove typologies. You can now use the same gasket 220-00-930-03 both for the sash and the frame. This will optimize the fabricator's work, dealing with only one gasket instead of using one gasket for the frame and a different one for the sash.
- 720-10-858-00 is composed of 2 profiles (AL10858) with a length of 350mm each.
- 720-10-859-00 is composed of 4 profiles (AL10859) with a length of 350mm each.
- 720-10-968-00 for 6mm inner glass
- 720-10-969-00 for 8mm inner glass
- 720-10-970-00 for 12mm inner glass
We would like to inform you that ALUMIL has developed a new profile, 303031, which is placed at the bottom of the rolling shutter, clicked on the terminal profile, to increase its overall mechanical performance.
This profile co-operates only with 35009 terminal profile and significantly enhances the shutter sturdiness and wind load resistance. The profile is accompanied by a pair of plastic caps, EX- 7653030100, as below. Both profiles and the corresponding caps are available for order.
Standard lengths
The following changes were made to the catalog:
- changes in all even typologies
- profil cuttings and accessory quantities added on corner typology
We have developed 2 new triple_track profiles for S650. The new track profiles are joint together with 3 sets of polyamides, thus offering a single profile code for the 3 track typology. Up until today, the 3 track profile was only feasible by joining together 3 different profiles. Now, we can have only one profile code for these tracks.
Note: The total width of these profiles is 250mm, so cutting can only be done with appropriate saw, able to cut this profile dimension. Fabricators can explore the possibility of cutting these profiles according to their saw machines.